[AMD] NANO-TECH T4(4-ply) Disposable Face Masks (50ea – 1box)

 

7 reasons you’ll love these P2 face masks:

• First P2/FFP2 certified respirator masks manufactured in Australia
• Nano-filter filters out 99.66% of airborne particles like virus’ as tested by VICLAB (BSI) 17.7.20 (compared to approximately 60% for many imported masks)
• Authorized by FDA through EUA for medical use
• Can be worn comfortably for up to 24 hours continuously
• Australia & NZ standard AS/NZS 1716:2012
• 4 protective layers to protect you from airborne virus’
• Cutting-edge nanotechnology, to make them light and breathable
• Bacterial Filtration Efficiency (BFE)  ≥98% AS 4381 Level 3
• Australia & NZ – P2 – AS/NZS 1716:2012

 

Directions

Before putting on the respirator P2 mask, wash hands for at least 20 seconds with soap and water or rub hands together thoroughly with alcohol-based hand sanitiser.

Take care not to touch the inside layer of the P2 respirator that will be in contact with the nose and mouth when unpacking and while donning.

Check for defects in the face respirator such as tears or broken loops.

Position the label side of the P2 respirator outward and orient the respirator so that the foam nose bridge strip is at the top.

Unfold the respirator P2 mask while holding onto the edges (again being careful not to touch the area that will be in contact with the nose and mouth). Position the unfolded respirator over the nose and mouth and place one earloop over each ear.

Mould the nose bridge wire to the bridge of the nose and while pinching the nose bridge in place stretch the bottom of the respirator to over the chin. Press along the edges of the respirator to maximise the seal.

Avoid touching the respirator while using it; if touched, clean hands with alcohol-based hand sanitiser or soap and water.

Replace P2 respirator if it becomes obviously contaminated; never reuse single-use respirators.

Removing the respirator

Wash hands with soap and water or alcohol-based hand sanitiser before removing the respirator. Remove the P2 respirator by unhooking the ear loops, taking care not to touch the front of the respirator which might have become contaminated. Discard immediately in a closed bin and clean hands with alcohol-based hand sanitiser or soap and water.

WARNING

Selection of the most appropriate Respiratory Protective Equipment (RPE) will depend on the particular situation and should be made only by a competent person knowledgeable of the actual working conditions and the limitations of the RPE. Details regarding performance and limitations are specified on the respirator packaging and user instructions. Before using any respirator, the wearer must read and understand the user instructions for the product. Use in accordance with AS/NZS 1716:2012 Standard. Misuse can result in sickness or death. For more information, consult a supervisor or contact an Occupational Health and Safety professional.